No products in the cart.
colorFabb Ultra Marine Blue PLA/PHA 3D Printer Filament – 1.75mm / 750g Spool
Some PLA filament can be brittle, but not colorFabb’s PLA/PHA. They compound PLA with PHA (polyhydroxyalkanoate) to create an incredibly tough filament that prints fast and easy. PHA is like PLA a bio-polyester, so this unique blend is still 100% biodegradable.
During the renaissance ultramarine was the most expensive pigment a painter could use.
$39.99
Out of stock
Material: colorFabb PLA/PHA
Actual Weight of Filament: 750g (approximate length on the spool is 245 meters)
Diameter Tolerance: ± 0.05 mm
Density: 1.210 – 1.430g/cm3
Glass Transition Temperature: 55°C
Suggested printing temperature: 195°C – 240°C*
Suggested print speed: 35 – 100 mm/s
Suggested heated bed temperature: 50-60°C
Build platform: colorFabb’s PLA/PHA filament adheres well to both heated and non-heated build platforms. We recommend using BuildTak as your bed’s printing surface.
If printing on a glass bed, apply glue-stick. A very thin layer of glue will be sufficient to keep your print nicely in place. Another gluing method is dissolving PVA glue in water. The consistency of the mixture can be quite thin, like skim milk. By applying just a few drops and smearing the mixture out before you start printing will create a very thin layer which will hold the filament down.
PLA/PHA and Warping: PLA/PHA has very minimal warping tendencies, however if you are printing parts which take up the maximum area of your build space you might see some warping. If it is important that your part is perfectly flat, than we suggest slowing the fan that is cooling your part. This allows the material to slowly get rid of heat without warping. After a few centimeters of layers have been printed, you can turn on the cooling fan if the part needs it
In-house testing
STACKER is continually testing our filaments to ensures the best quality possible. If you are not sure how to print with any material, please contact us at info@stacker3d.com.
Spool Size:
Outer Diameter: 200mm
Thickness: 70mm
Inner Diameter: 53mm
Tech Downloads: Technical data and MSDS sheets are available from colorFabb, http://colorfabb.com/Materials/
*3D printers have a wide variety of hot-ends which makes it extremely difficult to provide a universal printing temperature. The provided temperature range should be considered a starting point to help you find a temperature that works for your print. Please refer back to your printer’s operating manual for safety and temperature specifics.
The information below reflects shipping weight and dimensions (if applicable)
| Weight | 2 lbs |
|---|---|
| Dimensions | 9 × 9 × 3 in |
Related products
Out of stock
Out of stock
Out of stock
Stacker 500
$7,999.00
