Stacker Silver Support Tube for Filament Guide Tube
The STACKER 3D printer Silver Support Tube is used to support the filament guide tube when used with clips. The Silver Support tube is not a wear part; however, it is being made available just in case you damage or lose a Silver Support Tube.
Although Silver Support Tubes were not included with the Stacker 500, these can be added to any Stacker 500 to improve printer performance.
Sold in lengths of 875mm. STACKER recommends cutting your filament guide tube to the appropriate length for your printer.
$7.99
The STACKER 3D printer Silver Support Tube is made from premium quality nylon, dimensions: 4.3mm ID, 6.4mm OD, and 870mm length.
Please trim your Silver Support Tube to the appropriate length for your printer:
- S4 = 875mm
- S2 = 760mm
- S2 (with offset heat sink) = 750mm
- 500 = 675mm
Related products
Spare Parts
Nozzles and Heater Blocks
Nozzles and Heater Blocks
